VapeOnly Malle S Lite Portable Charging Kit 180mAh

VapeOnly Malle S Lite Portable Charging Kit 180mAh

Product Introduction

The VapeOnly Malle S Lite is a super portable device with convenient operations. It comes with 2 e-cigarettes and a 180mAh battery with each set to provide you with all the vaping you need all day long. It is also automatic so you don’t need to press any button when vaping – sooo easy! Together with the convenient charging box and easy bottom refilling atomizer, it is absolutely the perfect choice for daily use!

Parameters

Malle S Lite Case/Box:
Size: 35.5mm x 15.0mm x 116.0mm
Input Voltage: 5V
Input Current: 1A
Material: PC, ABS, Aluminum
The e-cig:
Size: 9.2mm x100.5mm
Battery Capacity: built-in 180mAh (each set)
Atomizer Volume: ≤0.8ml
Coil Resistance: 1.5Ω
Wattage modes: 8W
Material: Stainless steel tube + glass + brass + silicone

It comes with

• 1 x Malle S Lite Box (without battery)
• 2 x Malle S Lite e-cigs (180mAh built-in battery each set )
• 2 x Spare Coil
• 1 x USB Charger
• 1 x User Manual

Features

Super portable device with convenient operation
All day vape with elegance
Evolution of malle e-cig
180mAh built-in battery with easy bottom refilling atomizer

Operation Guide

How to fill the atomizer:
1. Upside down the device, hold the mouthpiece with one hand and coil base with another hand, and screw off the coil base;
2. Fill in the e-liquid along the glass tube slowly. (DO NOT fill the e-liquid in the smoke tunnel. )
3. Screw back the coil base.
Note: In order to let the e-liquid completely permeates through coil and avoid coil burnt, stand the atomizer for 5 minutes before using.

How to change the coil:
Unscrew the tank part from the battery, pull out the old coil and install a new one.

How to charge:
Put the e-cig in the compartment in the case, the corresponding red LED will light up, which shows it’s being charged. The LED will flash 20 times and go out when the e-cig is fully charged.

Low-voltage Protection: When the voltage is lower than 3.3V, the LED light will flash 10 times and go to standby mode.

Short Circuit: The light is on 2 seconds.

Overheat Protection: When the e-cig is over heat, it will stop working.